SMF-400/500/600/800 Plastic pvc pulverizing miller machine for pipe/profile/sheet/film/board

PVC pulverizing miller adopts rotor blade design to pulverize waste PVC materials into power for recycling. Widely used to recycle waste PVC ceiling panels, PVC wall panels, PVC profiles, PVC pipes, etc. It is an essential machine for pvc plastic factory.



Structural features for Plastic PVC miller:

1). Water circulation and air cooling, suitable for the processing of heat-sensitive materials.

2). With the swing tail airflow (partial eddy current) generated by the swing tail of the main shaft winch, the input swing tail material strongly collides with the plate and the cutting blade, and is ground into powder (not screened).

3). Both the plate and the blade are made of wear-resistant steel, which has excellent performance after heat treatment.

4). The structure is tight and the machine volume is small. If you open the door closed, you can maintain it. It is completely sealed without any dust leakage.

5). With a rewinding and reclaiming device, it has the characteristics of uniform cooling material and fast cooling.

6). Adopting a new type of grinding disc design, high output and strong resistance, the life of the grinding disc is doubled compared with the ordinary grinding disc.

7). Adopt newly designed professional bearings to achieve high speed. At the same time, only one drive motor is used to ensure efficient grinding collisions, which greatly saves time and operation in mechanical and control engineering.

8). It is easy to install and maintain, and the cover can be cleaned by opening the door.

9). Fully sealed milling, no dust leakage.

10). Fully automatic feeding, feeding and sorting.

11). The adjustment of the grinding gap is simple, just use the pin bolts for fine adjustment (10-120 mesh).

12). The main machine adopts the water and air dual system; the grinding chamber with small cross-section is reasonably designed, and the grinding is almost flat vertical surface. As soon as the material is caught, it enters the grinding chamber, is ground, and then quickly removed, eliminating the surge of material in the grinding chamber, heating the material to avoid decomposition, thereby increasing the output.

Technical Parameter

Model 400 500 600 800
Motor power(kw) 30 37 45 55
Blower power(kw) 1.5 3 5.5 11
Dust collector 6 9 16 24
Total power(kw) 31.5 42 52 90.5
Feed diameter(mm) <18 <18 <18 <18
Discharge size(mesh) 10-80 10-80 10-80 10-80
Capacity(kg/h) 100-150 200-250 300-400 400-500
Dimension(L*W*H) 2000*1800*26000 2500x2000x3000 3200x2600x3200 3500x2400x4000

Recommended Products

Please enter your message