LH-BS-10 Horizontal spiral ribbon lithium battery negative electrode chemical powder mixer

Horizontal Lithium battery  ribbon powder mixer structure:
The lithium battery ribbon mixer consists of a transmission component, a double-layer ribbon agitator, and a U-shaped/0-shaped barrel. There are feed ports, inspection ports, and discharge ports on the container barrel. Special functions such as spray liquid adding device, barrel rotation, and barrel jacket can be formulated according to user requirements. There is a discharge port in the center of the bottom of the barrel, which can be manually or automatically discharged according to production needs.

Process of horizontal Lithium battery powder ribbon mixer:
A1: The barrel of the equipment has a loading rate of about 70%, a high loading coefficient, and the equipment occupies a small space under the same loading capacity.
A2: The “U”-shaped barrel is welded together with the two end plates, and the overall strength of the barrel is high and the sealing is reliable. At present, there are problems with the “U”-shaped trough body on the market, which is bolted at one end, has sealing performance and accumulated residual materials
A3: The internal lining process of the cylinder body is advanced to ensure the bonding strength between the PTFE plate and the stainless steel base material. At the same time, the thickness is 2-3mm, which is much greater than the general spraying process and has a longer service life
A4: The stirring device adopts an interrupted form, which has less power consumption while ensuring the mixing uniformity, and is more suitable for some high-density materials. The stirring device can be sprayed with HALAR (Hara)/WC (tungsten carbide) according to customer requirements
A5: The stirring main shaft is flange-connected with the transmission shaft at both ends, which is particularly suitable for later maintenance. Especially after a few years, when the internal agitator spray is worn and needs to be re-sprayed, the internal agitator can be removed at any time
A6: The shaft seals at both ends are air-sealed, with excellent sealing performance, ensuring that no powder leaks at both ends
A6: The upper cover can meet the overall pneumatic opening and closing, and check the internal agitator and the spray wear of the inner wall of the U-shaped groove at any time. The upper cover and the U-shaped groove use a new sealing method and a special sealing strip to ensure that no powder leaks during the operation and mixing process. The upper cover and the U-shaped groove use a special hinge device, which does not break and has good fit
A7: Reasonable power and structure selection, which can realize load start, frequency conversion speed regulation, and match brand inverters

Horizontal mixer (ribbon type) optional modes:
A1: Liquid addition-liquid spray system.
A2: Chopper-high-speed chopper can eliminate the agglomeration or agglomeration of some materials during the mixing process. One device can be equipped with one or two choppers, which can be equipped on both sides of the machine cover or barrel discharge valve.
A3: Scraper device – scrapers are installed on the end of the barrel and the outer screw to reduce the mixing dead zone.
A4: Interlayer – the interlayer can be heated by heat transfer oil, hot water or steam. The user must provide the medium, pressure and temperature parameters.
A5: Vacuum operation – the equipment can be designed for vacuum operation or vacuum suction.
A6: Load start protection device – hydraulic coupling.
A7: Electric control box – usually no electric control box is provided, but it is provided when the user needs it.
A8: Speed: single speed, double speed and variable frequency speed regulation or stepless speed regulation are all available.
A9: Material: carbon steel, 304SUS, 316L stainless steel are available.